Fujitsu Arrows NX F-01J Instruction Manual page 197

*2 The SAR limit for mobile phones used by the public is 2.0
watts/kilogram (W/kg) averaged over ten grams of tissue,
recommended by The Council of the European Union.
The limit incorporates a substantial margin of safety to
give additional protection for the public and to account
for any variations in measurements.
*3 Including other radio systems that can be simultaneously
used with cellular radio wave.
*4 Tests for SAR have been conducted using standard
operation positions with the phone transmitting at its
highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the phone
while operating can be well below the maximum value.
This is because the phone is designed to operate at
multiple power levels so as to use only the power
required to reach the network. In general, the closer you
are to a base station antenna, the lower the power output.
◆ Federal Communications Commission
(FCC) Notice
･
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions :
a this device may not cause harmful interference, and
b this device must accept any interference received,
including interference that may cause undesired
operation.
･
Changes or modifications made in or to the radio phone, not
expressly approved by the manufacturer, will void the user's
authority to operate the equipment.
･
The device complies with 15.205 of the FCC Rules.
◆ FCC RF Exposure Information
This model phone meets the U.S. Government's requirements
for exposure to radio waves. This model phone contains a
radio transmitter and receiver. This model phone is designed
and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy as set by the FCC of
the U.S. Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for the
general population. The guidelines are based on standards
that were developed by independent scientific organizations
through periodic and thorough evaluation of scientific studies.
The exposure standard for wireless mobile phones employs a
unit of measurement known as the Specific Absorption Rate
(SAR). The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR
are conducted using standard operating positions as accepted
by the FCC with the phone transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR
level of the phone while operating can be well below the
maximum value. This is because the phone is designed to
operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to
a wireless base station antenna, the lower the power output
level of the phone.
Before a phone model is available for sale to the public, it must
be tested and certified to prove to the FCC that it does not
exceed the limit established by the U.S. government-adopted
requirement for safe exposure. The tests are performed on
position and locations (for example, at the ear and worn on the
body) as required by FCC for each model. The highest SAR
value for this model phone as reported to the FCC, when tested
for use at the ear, is 1.177 W/kg
*
is 0.917 W/kg . (Body-worn measurements differ among
195
*
, and when worn on the body,
Appendix/Index