Docomo Nano Uim Card - Fujitsu Arrows NX F-01J Instruction Manual

docomo nano UIM card

A docomo nano UIM card is an IC card that stores user
information, such as the users phone number.
･
You can use the terminal only with a docomo nano UIM
card. If you have a docomo mini UIM card, docomo UIM
card, or FOMA card, bring it to a docomo Shop to replace it
with a docomo nano UIM card.
･
If docomo nano UIM card is not inserted to the terminal,
some functions such as making/receiving calls and sending/
receiving SMS are not available.
･
For details on the docomo nano UIM card, refer to the
instruction manual for docomo nano UIM card or NTT
DOCOMO website.
◆ Installing/Removing a docomo nano
UIM card
･
Install/remove after turning OFF the power.
･
Be sure to use the tray when inserting a docomo nano UIM
card. Failure to do so may cause a malfunction.
■ Installing
a Face up the display side of the terminal and open the slot
cap hooking the groove with your fingertip (a)
b Put your fingertip on the groove of the tray and pull it
straight out (b)
･
The tray is designed to be removed from the docomo
nano UIM card slot.
c With the IC side facing up, place the docomo nano UIM
card on the tray (c)
･
Check the orientation of card's corner.
d Make sure that the display side of the terminal is facing
down, then insert the tray straight into the docomo nano
UIM card slot (d)
c
d
e Press firmly the slot cap of the terminal to close→P26
32
Corner cut
IC
Slot cap
Tray
a
b
Groove
Before using the terminal