Fujitsu Arrows NX F-01J Instruction Manual page 97

❖
TV watching screen
a
b
c
d
e
f
TV watching screen (Full Seg)
a Operation area
･
Watching mode (Full-seg/One-seg), mode change switch
(Auto/Fullseg/Oneseg), screen rotation, and menu icon
are displayed. In Full Seg, the following icons are
displayed.
(Data) : Display data broadcasting
(Remote control) : Display the remote control (for the
horizontal screen only)
･
If you tapped (Data) while viewing a Full Seg program
on the vertical screen to display data broadcasting, then
you can tap to display a remote control with control
icons that allow you to navigate the data broadcasting
screen.
b TV watching area
･
Flick left or right to switch channels.
c Control bar (for Full Seg only)
d Operation panel area
g
e Channel information area
f Navigation bar
g Controller
✔INFORMATION
･
You can adjust the volume by pressing the volume key when
the TV watching screen is displayed.
･
On the horizontal screen, the content is displayed full-screen.
Tap the screen to show the operation area, channel
information area, controller, and navigation bar.
95
･
When you tap an icon, the corresponding screen is
displayed in the operation panel area.
: Display the remote control
: Display a list of channels
: Display program information
･
Displayed contents can be switched by tapping each icon
on the control bar.
･
Display data broadcasting while viewing a 1Seg
program. To operate data broadcasting, touch the screen
to operate or tap control icons displayed below the
operation panel area.
Channel name, signal reception, multi broadcasting icon,
and program name are displayed.
/ : Start/Stop recording
/ : Switch the channel (Touch and hold to perform a
channel search)
･
If an unregistered broadcasting station is found by the
channel search, you can sisplay the list of channels→
Touch and hold an empty channel→Tap [YES] to add the
station to the channel list.
: Pop-up the list of channels
Applications