ABB ACS 601 Hardware Manual page 65

Industrial Low-Voltage
Network
ACS 600 Type
ACS/ACC/ACF/ACP 601
ACS/ACC/ACF/ACP 604
ACS/ACC/ACF/ACP 607
(55 to 630 kW)
ACS/ACC 607
(630 to 3000 kW)
ACS 600 MultiDrive
Supply Section
Drive Section
ACS/ACC/ACP 601 Drives
The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used in European Economic Area. The EMC product standard EN 61800-3
covers the requirements stated for drives.
The ACx 601 drives comply with the EMC Directive in industrial low-voltage network,
public low-voltage network (restricted distribution) and IT networks (ungrounded
power) with the following provisions:
1. It is ensured that no excessive emission is propagated to neighboring low-voltage
networks. In some cases, the natural suppression in transformers and cables is
sufficient. If in doubt, the ACx 600 can be equipped with EMC filtering (refer to
Table A-1) or the supply transformer with static shielding between the primary and
secondary windings can be used.
2. The ACx 601 is installed with motor and control cables as specified in this
manual.
Note: It is recommended to equip the ACx 600 with the EMC filtering if there is
equipment sensitive to conducted emission connected to the same supply transformer
as the ACx 600.
Table A-1 The EMC filtering of the ACx 600 units is marked in the type code as
follows. * du/dt Filters + EMC Filters, ** du/dt Filters + No EMC Filters, *** EMC Cabinet
with EMC Filters.
Character no.
ACxxxxxxxxxxxxxxxxxxxx
ACxxxxxxxxxxxxxxxxxxxx
ACxxxxxxxxxxxxxxxxxxxx
ACxxxxxxxxxxxxxxxxxxxxxxxxx...
ACA63xxxxxxxxxxxxx...
ACA610xxxxxxxxxxxx...
Appendix A – ACS/ACC/ACP 601 Technical Data
Type Code
EMC Filter
Selections
0
20
0
20
0, 3*
20
1, 2***
26
1, 2***
16
1
16
ACx=ACS/ACC/ACP
No EMC Filter
Selections
9
9
5**, 9
0,
0
0
A-21