Applicable Standards; Materials; Disposal; Ce Marking - ABB ACS 601 Hardware Manual

Appendix A – ACS/ACC/ACP 601 Technical Data

Applicable Standards

Materials

Enclosure (ACx 601)
PS (polystyrene) 3 mm (0.12 in)
hot-dip zinc coated steel sheet 1.5 to 2 mm(0.06 to
0.08 in) painted with epoxy polyester powder paint
anodized aluminium profile (R2 to R6)
Package (ACx 601)
corrugated board (frames R2 to R5 and option modules), plywood (R6). Plastic covering of the package: PE-LD, bands
PP or steel.

Disposal

CE Marking

Compliance with the
EMC Directive
A-20 ACx=ACS/ACC/ACP
The ACS 600 complies with the following standards:
• EN 60204-1: 1992 + Corr. 1993 (IEC 204-1). Safety of machinery.
Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is
responsible for installing
- an emergency-stop device
- a supply disconnecting device (ACx 601 and ACx 604)
- the ACx 604 (IP 00) into a separate casing.
• EN 60529: 1991 (IEC 529), IEC 664-1: 1992. Degrees of protection
provided by enclosures (IP code).
• EN 61800-3 (1996): EMC product standard including specific test
methods.
Thickness of
Coating
60 µm
ACx 600 contains raw materials that should be recycled, thus
preserving energy and natural resources. Package materials of
ACx 600 units and options are environmentally compatible and
recyclable. All metal parts can be recycled. The plastic parts can either
be recycled or burned under controlled circumstances, according to
local regulations. If recycling is not feasible, all parts excluding
electrolytic capacitors can be landfilled. The DC capacitors of the unit
contain electrolyte which is classified as hazardous waste. (Location of
the electrolytic capacitors is shown on a sticker in the back of the front
cover, C11 to C13.) They must be removed and handled according to
local regulations.
For further information on environmental aspects, please contact your
local ABB distributor.
A CE mark is attached to ACx 601/607 drives to verify that the unit follows the
provisions of the European Low Voltage and EMC Directives (Directive 73/23/EEC, as
amended by 93/68/EEC and Directive 89/336/EEC, as amended by 93/68/EEC).
EMC stands for Electromagnetic Compatibility. It is the ability of electrical/electronic
equipment to operate without problems within an electromagnetic environment.
Likewise, the equipment must not disturb or interfere with any other product or system
within its locality.
Color
NCS 1502-Y (RAL 90021 / PMS 420 C)
NCS 8502-Y (RAL 9004 / PMS 426 C) semigloss
black ES 900
ACS/ACC/ACP 601 Drives