External Control Connections (Niocp) - ABB ACS 601 Hardware Manual

Appendix A – ACS/ACC/ACP 601 Technical Data
External Control
Connections (NIOCP)
A-8 ACx=ACS/ACC/ACP
External control connections of ACP 600 with NIOCP board are below.
Terminal Block X1
1 +10 V
2 AGND
3 –10 V
4 AI1+
5 AI1–
6 AI2+
7 AI2–
8 AO1+
rpm
9 AO1–
Terminal Block X2
1 DI1
2 DI2
3 DI3
4 DI4
5 DI5
6 DI6
7 DI7
8 DI8
9 DI9
10 DI10
11 DI11
12 DI12
13 +24 DV
14 +24 DV
15 +24 DV
16 DGND
Terminal Block X4
1 +24 V
2 DGND
Terminal Block X5
1 +24 DV
2 DO1
3 DO2
4 DO3
5 DO4
6 DGND
Terminal Block X7
1 RO1 NCC
2 RO1 CM
3 RO1 NOC
Terminal Block X8
1 UENC+
2 SENSE+
3 SENSE–
4 UENC–
5 A+
6 A–
7 B+
8 B–
9 Z+
10 Z–
Function
Reference Voltage +10 VDC
2 kΩ ≤ R
Analog Ground
max. 10 mA
Reference Voltage –10 VDC
External Reference 1: Speed
Analog input signals 1 and
Reference
2, signal level ±10 V, input
impedance ≥ 20 kΩ,
External Reference 2: Not
resolution 12 bit
defined
Signal level ±10 V,
SPEED ACT 1 R
resolution 8 bit
START/STOP
RAPID STOP NOT
FAULT RESET
SPEED REF SWITCH
12 digital inputs for different
ACC/DEC 1/2 SEL
control configurations.
Signal level 24 VDC, typical
input current 8 mA, opto-
isolated as a group,
≤ 8 V = "0"; ≥ 12 V = "1"
Not defined
+24 VDC,
Control Voltage Output
total max 135 mA
Digital Ground
Auxiliary Voltage Output
+24 V
0 V
Control Voltage Input
ACT SPEED=0 Voltage 24 V, current 10 mA
each (internal supply) and
RUNNING
100 mA each (external
FAULT (-1)
supply), optoisolated as a
ACT SPEED=REF
group,
≤ 8 V = "0"; ≥ 12 V = "1"
Digital Ground
Max. switching voltage 120
VDC/250 VAC, max
1 Relay Output, READY Signal switching current/power 2 A
at 24 VDC or 250 VAC, 0.4
A at 120 VDC, 500 VA
Power Supply SUBD X6:4
Sense+ SUBD X6:5
Sense– SUBD X6:13
0 V SUBD X6:12
Channel A+ SUBD X6:1
Channel A– SUBD X6:9
Channel B+ SUBD X6:2
Channel B– SUBD X6:10
Channel Z+ SUBD X6:3
Channel Z– SUBD X6:11
ACS/ACC/ACP 601 Drives
Specifications
≤ 10 kΩ
LOAD
≥ 1 kΩ ,
LOAD