Replacing The Direct-On-Line (Option +C188) Module Fan (Frame R8I) - ABB ACS880-207 Hardware Manual

Replacing the direct-on-line (option +C188) module fan (frame R8i)


If the module is equipped with a standard speed-controlled cooling fan, see page 75.
WARNING! Only qualified electricians are allowed to this work. Read the
complete safety instructions of the drive. Ignoring the instructions can cause
physical injury or death, or damage to the equipment.
1. Disconnect the drive from the AC power line and make sure it is safe to start the work.
See section Electrical safety precautions
2. Open the door.
3. Remove the shroud in front of the fan.
4. Unplug the wiring of the fan.
5. Undo the screws of the fan.
6. Pull out the fan.
7. Install a new fan in reverse order.
on page 42.
4
5
6
Maintenance 77