Checking Vtr/Disk Recorder Information - Sony DVS-9000SF User Manual

Checking VTR/Disk Recorder Information

You can check the VTR/disk recorder information (timecode information and
VTR/disk recorder operating status) set in the device control block, in the
Device menu display.
To check the VTR/disk recorder information, press VF3 'VTR' and HF1
'Cueup & Play' or HF2 'Timeline' in the Device menu.
The Device>DDR/VTR>Cueup & Play menu or Device>DDR/
VTR>Timeline menu appears, and a list shows the timecode information and
operating status for each device. The columns of the list show the following
information.
DEV (device name): DEV1 to DEV12 represent respectively device 1 to
device 12.
Reg (register): Number of the register to which settings apply.
Status: Status of each device. The meaning of the indications is as follows.
Operating
status display
XXXX
Local
Tape Out
Rec
Cue>
Cue<
Eject
Stb Off
Stop
Play
FF
Rewind
Shtl>
When VTR or Sony disk
9-pin protocol is used
Communications with the
device are being carried
out normally, but status
information is not received.
The REMOTE/LOCAL
switch of the device is set
to LOCAL.
No tape is loaded (VTR).
No file loaded.
(Sony disk 9-pin protocol)
Recording.
Cueing up in the forward
direction.
Cueing up in the reverse
direction.
Ejecting cassette.
Stopped in standby off
mode.
Stopped in standby on
mode.
Playing.
Fast forwarding.
Rewinding.
Playing in the forward
direction in shuttle mode.
When video disk
communications protocol is used
Not communicating, or
communicating but the device type
cannot be read.
Port is not open.
No file loaded.
Recording.
—
—
—
—
Stopped.
Playing.
—
—
—
Control of VTRs and Disk Recorders
137