Sony DVS-9000SF User Manual page 333

2
Using any of the following methods, specify the serial port.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
3
Press [Clear].
Making detailed settings on the external device connected to the
serial port
After setting the external device for each serial port, it is necessary to make
further detailed settings for operation of the external device.
To make detailed settings for a VTR
Use the following procedure.
1
In the <DCU Select> group of the DCU>Serial Port Assign menu, select
the target for the setting (DCU1 or DCU2).
2
Using any of the following methods, select the serial port connected to the
VTR for which you want to make the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
3
Press [Port Setting].
The DCU>Serial Port Assign>VTR Setting menu appears.
At the top of the status area, the relevant serial port, slot number, protocol,
serial port name, SCU number, and timecode source appear. In the lower
part of the status area, the VTR constants appear.
4
In the <TC Source> group, select the timecode source (reference signal for
determining the tape position) from the following.
LTC+ (Longitudinal Time Code): Normally LTC is used, but when the
tape speed is such that LTC cannot be read (
below), or the LTC cannot be read for some other reason, this is
interpolated using CTL pulses or timer counter pulses.
Parameter Adjustment
Port No Serial port
Parameter Adjustment
Port No Serial port
Setting values
1 to 30
Setting values
1 to 30
1
/ normal speed or
8
Setup Relating to DCU
333