Cropping the image
Use the following procedure.
1
In the DME menu, select VF1 'Edge' and HF1 'Border/Crop.'
The Border/Crop menu appears.
2
Press [Crop], turning it on.
The Crop effect is enabled. You can adjust degree of cropping with the
knobs.
3
Set the parameters.
The valid ranges of the parameter values depend on the aspect ratio (4:3/
16:9) selected in the system, as follows.
• 4:3 mode
Knob
1
2
3
Knob
1
2
3
4
• 16:9 mode
Knob
1
2
3
Parameter group [1/2]
Parameter
Adjustment
H
Crop positions on left and right
sides
V
Crop positions on top and
bottom sides
All
Crop positions on all sides
Parameter group [2/2]
Parameter
Adjustment
Top
Crop position on top side
Left
Crop position on left side
Right
Crop position on right side
Bottom
Crop position on bottom side
Parameter group [1/2]
Parameter
Adjustment
H
Crop positions on left and right
sides
V
Crop positions on top and
bottom sides
All
Crop positions on all sides
Setting values
Left value shown
Top value shown
Left value shown
Setting values
–3.00 to +3.00
–4.00 to +4.00
–4.00 to +4.00
–3.00 to +3.00
Setting values
Left value shown
Top value shown
Left value shown
DME Special Effect Operations
27