Type Modbus; Selection And Activation Of The Sensor Type; Modbus Settings - Beko METPOINT BDL compact Instructions For Installation And Operation Manual

14.3.2.9 Type Modbus

14.3.2.9.1 Selection and activation of the sensor type

First step: select a free sensor channel
Main menu  Settings  Sensor settings  A1
Second step: select the Modbus type
Main menu  Settings  Sensor settings  A1  Type text field  Modbus
Third step: confirm with
Now, a name (see Chapter
Main menu  Settings  Sensor settings  A1  Right arrow (2

14.3.2.9.2 Modbus settings

Main menu  Settings  Sensor settings  A1  Right arrow (2
text field
Main menu  Settings  Sensor settings  A1  Reg. address text field
54
OK
12.2.2.7 Marking and setting text
Operation METPOINT® BDL compact
fields) can be entered.
page)  VA  Use
nd
Via Modbus, up to eight registry values
(from input or holding registers) of the sen-
sor can be read out.
Selection via the register tabs
activation by means of the respective
button.
page)  Modbus settings ID
nd
Here the Modbus ID is entered which is deter-
mined for the sensor, permissible values are
247, (ex. here Modbus ID = 12)
In addition, the serial transmission settings
rate, stop bit, parity bit, and timeout time
be defined.
When the BDL compact is connected to the end of
the bus, the termination can be activated via the
Term button, or a BIAS energised via the
ton.
Confirmation with OK.
Resetting to the initial settings by means of the
to default button.
Please refer to the data sheet of the sensor for the
setting of the Modbus ID and the transmission set-
tings.
Va –Vh and
use
1 –
baud
need to
Bias but-
set
METPOINT® BDL compact