Storage And Transport - Beko METPOINT BDL compact Instructions For Installation And Operation Manual

Storage and transport

7 Storage and transport
Despite all due care and attention, transport damage cannot be excluded. Therefore, check the
®
METPOINT BDL compact for possible transport damage subsequent to transport and removal of the
packaging material. The forwarding agent and BEKO TECHNOLOGIES or the BEKO
TECHNOLOGIES agency shall be informed immediately about any kind of damage.
Warning!
Overheating!
Overheating will destroy the evaluation unit. Observe the permissible storage and transport
temperature, as well as the permissible operating temperature (e.g. protect the measuring
device against direct sunlight).
Warning!
Damage possible!
Damage may occur to the METPOINT
of unsuitable lifting tools.
Measures
• The METPOINT
skilled personnel.
• Only use suitable and technically sound lifting tools for the transport.
• In addition, observe the respectively valid regional provisions and directives.
Caution!
Danger through damaged components!
Do not start-up a damaged METPOINT
erational reliability, falsify the measuring results, and cause further damage.
METPOINT® BDL compact
®
BDL compact must only be transported or stored by authorised and trained
®
BDL compact through improper transport, storage, or use
®
BDL compact. Defective components can impair the op-
®
Store the METPOINT
packaging in a closed, dry, and frost-protected room.
The ambient temperatures must not exceed/underrun
the values indicated on the type plate.
Protect the device against atmospheric influences
even when packaged.
®
The METPOINT BDL compact must be protected
against tilting-over, falling, and vibrations at the place
of storage.
BDL compact in its original
9