Chapter 4 Retrofitting Options
To Retrofit A5 DC Power Input Assembly (Option 002)
4
Insert and tighten the two hex screws (H4) and the lock washers
(H5) onto the HP-IB connector that protrudes from the rear of the
chassis using the 7-mm spin tight.
5
Now, re-install the front bezel by performing the front bezel
removal procedure, in Chapter 3 of this guide, in reverse. Be sure
to insert A2 Display Board's cable into connector J6 on
A1 Motherboard Assembly.
6
Tighten the three H1 screws, shown in Figure 4-1A, to secure the
motherboard to the chassis.
H2
H2
J18
Figure 4-1B. DC Power Input Assembly Retrofitting
4-6
A4 AC Power Supply
Assembly
H1
Assembly-Level Service Guide