Description Of The Appliance; Technical Data; Shaving Without The Power Cable - Silvercrest SFR 2.4 A1 Operating Instructions Manual

Personal care
Table of Contents

Advertisement

Description of the appliance

1 Cutter foil retainer
2 Release tabs
3 Locking button
4 On/Off switch
5 Charge-LEDs
6 Socket
7 Storage case
8 Brush
9 Mains power adapter
0 Connection plug
q Long hair trimmer
w Protective cap

Technical Data

Mains adapter
Input voltage:
Output Voltage:
Protection class:
Electric razor
Input voltage:
Batteries :
Protection class:
Shaving without the
power cable
Note:
On to the first usage, there could be production re-
lated oil residues on the cutter foil. Wipe them off with
an absorbant and lint-free cloth.
100 - 240 V ~
50/60Hz
4 V
400 mA
IPX4
4 V
400 mA
+
2 x AAA, Ni-MH
IPX4
Attention! Appliance Damage!
NEVER use the razor in the bathtub or shower. This
could irreparably damage the appliance.
This razor can be used without the power cable. In
this case, you must charge it before the f f i i r r s s t t use for
about 14 hours.
1. Check to ensure that the appliance is switched off.
2. Insert the connector plug 0 into the socket 6
on the razor. Pay heed to the correct polarity:
The guide pillar in the socket 6 must grip the guide
rail on the connector plug 0. If it does not, the
connector plug 0 cannot be inserted.
3. Connect the plug with a mains power socket. The
batteries are being charged.
Note:
To optimise the life of the batteries, if possible do not
interrupt the charging process until the batteries have
been fully charged.
Furthermore, it can happen that if you interrupt the
charging process, the charge LEDs 5 will not indi-
cate the correct load capacity of the battery's!
The charge LEDs 5 indicate to what extent the ap-
pliance is charged: The more charge LEDs 5 there
are that glow permanently, the higher the current
charge is. When the appliance is fully charged (from
a complete discharge, this will be after about 8
hours), remove the connection plug 0 from the
socket 6 and disconnect the power adapter 9 from
the mains power supply. The razor can now be used
without the power cable.
Note:
The full charging process after complete discharge
of the batteries takes approx. 8 hours. You can then
use the razor for approx. 60 minutes.
- 3 -

Advertisement

Table of Contents
loading

Table of Contents