Configuring Sequence Cross-References - ABB COM600 series User Configuration Manual

1MRS755001
4.11.
COM600 series 5.1
Sequence Control Configuration Manual
Figure 4.10-1 Adding Sequence POU to PLC MainTask
2. In the Input Assistant dialog, select Categories tab and Select program object.
3. Continue to build the program by selecting Build > Rebuild in the menu bar.
4. Update the build to COM600 Runtime. For more information, see COM600 Logic
Processor User's manual.
5. In case of excessive build errors, make sure that the sequence control library is
referred to in the Logic Editor project. To check this, click Library Manager in
the Devices view and verify that Sequence Control Library is listed as one of the
libraries. If not, click the Add library link and select Sequence Control Library
under Miscellaneous in the Add Library dialog.
6. Exit Logic Editor and open SAB600 before proceeding to the next configuration
steps.

Configuring sequence cross-references

This section describes the steps involved in configuring cross-references needed for the
sequence control functionality. For generic information on the concept of cross-references
between COM600 communication structure and Logic Processor variables, see COM600
Logic Processor User's Manual.
To configure cross-references for sequence control:
1. In SAB600 project, right-click the Logic_Processor IED and select Cross References
to launch the Cross References tool, see Figure 4.11-1.
The Cross References tool shows all the member variables associated with the
declared global variable (see 4.3, Creating a global variable list).
Logic_Editor_Add_Sequence_POU.png
37