Restoring A Configuration - ABB C1300 User Manual

C1300
Advanced circular chart recorder

3.16.2 Restoring a Configuration

1
Connect the Configurator Cable to the recorder's
configuration backup port (see Fig. 3.5) and the PC's serial
port.
5
Run the software 'C1300 Configuration Backup Utility.exe'
on the PC.
6
Restore the configuration – see Fig. 3.7.
7
Exit the C1300 Configuration Backup Utility Software.
8
Disconnect the Configurator Cable.
9
Press the key to return the recorder to normal
operation – see Section 2.3.1, page 8.
IM/C1300 Rev. J
2
Press the key to
open the Main Menu.
3
Highlight Common
any of the Configuration
level selections below
Common).
4
Press the and
keys simultaneously
place the recorder into PC
Config Mode.
Select the port to which
1
the configurator cable is
connected
(or
Ensure 'Download Config.'
radio button selected
to
5
The following message is displayed
Note. The following warning is displayed if an
incorrect port was selected in step
recorder is not connected correctly to the PC.
Note. Select a location away from strong electrical
and magnetic fields. If this is not possible,
particularly
communications equipment is expected to be
used, screened cables within earthed metal
conduit must be used.
The following is displayed when upload is
6
complete
Fig. 3.7 Restoring a Configuration
3 Configuration
Select the configuration file
3
to be restored
Click to restore the
2 4
configuration backup file
or the
1
in applications where mobile
59