Table of Contents
Advertisement
About projector condition
Status
Normal..............................................Projector is operating normally.
Power management in operation......Power management is operating
Lamp failure......................................Lamp failure is occurring
Abnormal Temperature .....................The temperature of the projector became too high
Cooling down after Abnormal Temp............. Projector detects abnormal temp. and is cooling down itself.
Standby after Abnormal Temp. ..................Projector detects abnormal temp. and sets into standby mode.
Power failure ........................................Power failure has occurred inside the projector. Projector is turned
When a security (PIN code lock) has been set on the projector, you also cannot con-
trol it through the network. To control the projector through the network temporarily,
execute "PJ lock suspend" command to unlock the security. "PJ lock suspend" is on
setting sub menu [3] on Setting main menu. (☞p.48)
✐ The projector cannot be turned on during the projector is on cooling down.
✐ The web browser checks and updates the projector's condition every 30 seconds automatically.
Description
off. Disconnect the AC cord and ask servicing to a qualified service
personnel.
If the power failure occurs on the projector, "Power failure" is
indicated on the status column and the information icon appears
on the power column as shown below. Click this icon to display
further information of the power failure.
Click this icon to display
further information of
the power failure.
Power control and status check
PJ-NET ORGANIZER
OWNER'S MANUAL
41
Advertisement
Table of Contents
