Q&A - Sanyo PJ-Net Organizer Plus POA-PN40 Owner's Manual

Q&A
Installation/Access
Q
Why doesn't the setting page appear in my web browser?
A
Following causes are possible. Please check them.
1. The projector does not connect to the network.
Check LED indicators status (☞ p.15).
- Check the connection of LAN cable if the LINK indicator does not light
orange.
- Check the network configuration of the projector if ACT indicator does
not light green.
2. Function "Network" in the projector is not set to "ON".
Set up by using the projector's on-screen menu (☞ p.18).
3. Wrong network configuration of the projector
Check the network configuration of the projector by using the
projector's on-screen menu (☞ p.18).
4. Wrong network configuration of the computer.
Check the network configuration of the computer.
5. The Network Unit is used with the default setting (☞ p.18).
6. The proxy setting of the web browser is not set correctly (☞ p.72).
7 . The computer does not provide TCP/IP protocol.
Q
No setting page in my web browser? Is the problem in the network or
in the projector? I would like to find out the problem whether it is in
the network or in the projector
A
Check it by the following steps
1. Disconnect the projector from the network and connect the projector and
computer with the UTP cross cable directly.
2. Change network configuration of the computer and projector as shown in
the example below.
(Projector setting)
IP Address
Subnet Mask
Default gateway
DNS
(Computer setting)
: 192.168.0.2 IP Address
: 255.255.255.0 Subnet Mask
: 0.0.0.0 Default gateway
: 0.0.0.0 DNS
Q&A
: 192.168.0.5
: 255.255.255.0
: (blank)
: (blank)
PJ-NET ORGANIZER
OWNER'S MANUAL
79