Table of Contents
Advertisement
[Notes]
(1) On Windows 2000, you have to execute the command only when the adapter port is
connected to the IO device and at least one device (disk) is identified.
(2) FLASH-ROM backup file name stored by backup command includes PCI vendor ID, PCI
device ID, WWN, the firmware version.
(3) If you execute the update using 'all' option, the execution continues for the next port when
the update process failed for the current adapter port. You can specify only one update file.
Hitachi Gigabit Fibre Channel Adapter has its own binary file for FLASH-ROM depending on
its device ID. If there are multiple types of Hitachi Gigabit Fibre Channel Adapter exist on
the same system and execute the update command specifying 'all' option, the command
always display the error. FLASH-ROM backup file stored by backup command has WWN
inside the file. So the error is displayed except for the target adapter which has the same
WWN.
[Error message]
The table below shows the error message when the firmware update tool 'hfcmcup' is
executed. When these errors occur, the following processing is interrupted and the program
is ended except specifying all option.
No.
Error messages
Actions to be taken
1
Open error.(xxx)
Confirm whether the specified device is not opened by other applications and
also specified device name is correct.
If device name is correct, wait for a while and retry the command.
If error messages is displayed when you retry the command, please contact
maintenance personel or support service.
2
unknown device_id
(func=hfc_device_type_get)
Confirm that specified device is Hitachi Fibre Channel adapter.
3
Unsupported device id.
Installed driver and utility tool may not support specified adapter. Refer to
HITACHI Gigabit Fibre Channel Adapter USER'S GUIDE (Support Matrix
Edition) for details.
4
Flash erase error.
(It failed in the elimination of flash)
Please contact maintenance personel or support service.
5
Invalid parameter.
Confirm input parameters and retry command.
6
memory allocate error Calloc error.
Free memory is short of executing the tool.
Terminate other application which consuming memories.
7
No valid microcode file for <filename>
was found in that directory.
Microcode files for this adapter have the
naming
convention
XXXXXX is the level of the microcode.
Confirn the directory you specified and retry command.
8
Input file open error(file name <filename>) Failed to open update file.
Confiem the attribute of specified update file.
Error Message List of hfcmcup
<filename>XXXXXX
where
140
Description
Failed to open device
Unknown device id is specified
Soecified adapter is not supported.
Failed to erase FLASH-ROM.
Input parameters are not correct.
Failed to allocate memory.
Update file does not exist on the
specified directory.
Advertisement
Table of Contents
