Table of Contents
Advertisement
Restore the HBA BIOS Setup Data
[Function] The HBA BIOS setup data in the restore file is displayed. Make sure that the value to
be set is contained and restore it.
[Syntax]
hfcmgr –rs <logical-device-name> <restore-file-name> [force]
force
[Example]
Figure Sample of hfcmgr –rs execution
# ./hfcmgr -rs hfcldd2 ./300B1054.05.01.01.00.BK
Backup data
BIOS
Boot Priority
Target WWN
-------------------------------------
1 0000000000000000
2 5000087000123456
3 0000000000000000
：
Additional WWPN
Login Delay Time
Pre Configure
BIOS data restore command.
Do you execute it? (y/n) > y
Time:xxxx/xx/xx xx:xx:xx
Succeeded.
You need reboot system to reflect setting changes to the system.
#
[Detailed description]
Refer to [Detailed description] in "Back up the HBA BIOS Setup Data."
[Notes]
(1) In order to translate into the driver after the set command is successfully executed, the
system must be rebooted.
(2) This command cannot be used if operating on the LPAR manager of Hitachi Server
Virtualization Mechanism.
(3) FLASH-ROM data is updated when you set parameters. While the command is being
executed, do not close the operation Window, terminate the command forcibly, or perform
operations such as turning off the power of the server unit or rebooting. The FLASH-ROM
data may be destroyed and HBA becomes unavailable.
# Omit the (y/n) confirmation message to execute the command
: disable
: enable
LUN
Priority
00
HIGH
00
00
: 0000000000000000
: 3 sec
: disable
61
Advertisement
Table of Contents
