Procedure Of Registering Io Devices; When Adding Io Devices Online - Mitsubishi Electric MELSEC iQ-R Series User Manual

3.2

Procedure of Registering IO Devices

This section describes the procedure of adding IO devices in the PROFINET setting. IO devices can be added both online and
offline.

When adding IO devices online

When adding IO devices online, meet the following conditions. If an IO device name and IP address do not meet the
conditions, set them again in the "Devices on the Network" window. ( Page 75 "Devices on the Network" window)
• The RJ71PN92 and IO devices have been connected to the network.
• A name has been set to the IO device, and the name does not duplicate with other IO devices.
• An IP address has been set to the IO device, and the IP address does not duplicate with other IO devices.
1.
Add the IO devices used in "Device Library". ( Page 69 Adding IO devices)
2.
Detect the IO devices on the network. ( Page 73 Network Detection)
Select the [Network Detection] tab.  [Network]  [Read Network Configuration]
3.
Add the detected IO devices in the network configuration settings.
When adding IO devices one by one
Select an IO device in "Network Detection".  [Network]  [Insert in Configuration]
When adding IO devices at once
Select the [Network Detection] tab.  [Network]  [Insert and Replace All]
• When IO devices are added one by one to the network configuration setting, "Device Name" which is set in
the detected IO device is registered to "Name" in the IO device setting window.
• When IO devices are added at once to the network configuration setting, "Name" in the IO device setting
window is registered in the format as "DEVICE_A" or "DEVICE_B".
3 GX Configurator-PN
98
3.2 Procedure of Registering IO Devices