Precautions - Mitsubishi Electric MELSEC iQ-R Series User Manual

2.7

Precautions

This section describes precautions related to parameter settings.
Verifying projects
Projects including an RJ71PN92 cannot be verified.
Reading, verifying, and deleting the PROFINET module setting
These operations cannot be performed in the window for writing the PROFINET module setting. To perform the operations,
use the following methods.
■Reading the PROFINET module setting
Create a backup file of the PROFINET module setting with the RJ71PN92 as shown below.
Note that the setting details of the PROFINET module setting cannot be checked in GX Configurator-PN. ( Page 102
Backup with the RJ71PN92)
[Navigation window]  [Parameter]  [Module Information]  [RJ71PN92]  Right-click  [Upload Config. Image]
■Verifying the PROFINET module setting
Verify PROFINET module setting data as shown below. ( Page 54 Verifying the PROFINET module setting)
[Navigation window]  [Parameter]  [Module Information]  [RJ71PN92]  Right-click  [Verify Configuration]
■Deleting the PROFINET module setting
Perform the following operation.
1.
Create a project and open GX Configurator-PN.
[Navigation window]  [Parameter]  [Module Information]  [RJ71PN92]  [PROFINET Module Setting]
2.
Save the project without setting anything and close GX Configurator-PN.
[File]  [Save]
3.
Write the PROFINET module setting to the RJ71PN92. ( Page 61 Writing the PROFINET module setting)
2 PARAMETER SETTINGS
62
2.7 Precautions