Mitsubishi Electric MELSEC iQ-R Series User Manual page 55

Own Node Setting
Set the IP address and name of the RJ71PN92.
Item
IP Address IP Address
Setting
Subnet Mask
Default Gateway
Controller Name
*1 When the parameter is written without the IP address setting (empty), the following address is set.
192.168.3.3
*2 When the parameter is written without the name setting for the RJ71PN92 (empty), the following name is set.
rj71pn92
*3 Usable characters: a to z, 0 to 9, "." (dot), "-" (hyphen). "-" cannot be used at the beginning and end of the name.
The name can be separated by ".". The number of characters in each separated part is limited to 63 or less.
Description
Set the IP address of the RJ71PN92.
Set the IO devices which exchange data with the RJ71PN92 so that they have
the same class and subnet address. Contact the network administrator before
setting the IP address.
Set the subnet mask of the RJ71PN92.
When setting the IP address of the default gateway and performing
communication with an external device in other network through a router, set the
subnet mask pattern of the default gateway. All the devices in the same
subnetwork should have a common subnet mask. The subnet mask setting is not
required for the communication in the single network.
Set the default gateway of the RJ71PN92.
Set the IP address of the relay device (default gateway) to access the IO device
in another network.
Set a value which satisfies the following conditions as the IP address of the
default gateway.
• The class of the IP address is A, B, or C.
• The subnet address of the default gateway is the same as that of the
RJ71PN92.
• The host address part is not a sequence of "0" or "1".
*2
Set the name of the RJ71PN92.
*1
Setting range
• Blank
• 0.0.0.1 to 223.255.255.254
(Default: Blank)
• Blank
• 128.0.0.0 to 255.255.255.252
(Default: Blank)
• Blank
• 0.0.0.1 to 223.255.255.254
(Default: Blank)
Up to 240 one-byte alphanumeric
*3
characters
(Default: Blank)
2 PARAMETER SETTINGS
2.2 Basic Settings
2
53