Firmware Update" Configuration Page - ABB 83342-500 Operating Instructions Manual

Operating Instructions
®
ABB Welcome
6.11

"Firmware Update" configuration page

Fig. 19: "Firmware Update" configuration page
The IP-Gateway has the option to manually update the device software.
Note
Device updates are not normally required and should only be performed for troubleshooting
purposes. To update the device, please contact your electrical installer.
Note
Before updating the firmware, always check if the update has a date more recent than the software
already installed. See the section "Version information."
Pos: 64 / #Neus truk tur #/Onlin e-D okum enta tion (+KNX)/St eue rmo dule - O nline-D oku ment ation (- -> Fü r alle D oku ment e < --) /++ ++ ++ +++ ++ + Seite nu mbr uch +++ ++ ++ +++ ++ @ 9\ mod _12 688 986 680 93_0 .docx @ 5 214 9 @ 2 221 212 122 222 222 2222 222 222 222 222 222 2222 222 222 222 222 222 2222 222 222 222 222 222 222 2222 222 222 222 222 222 2222 222 222 222 222 222 222 2222 222 222 222 222 222 2222 222 222 222 222 222 222 2222 222 222 222 222 222 2222 222 222 222 222 222 222 2222 222 222 222 222 222 2222 222 222 222 222 222 2222 222 222 222 222 222 222 2222 222 2222 222 2222 222 222 222 222 222 222 2222 222 222 222 222 222 2222 222 222 222 222 222 222 2222 222 222 222 222 222 2222 222 222 222 222 222 2222 22 @ 1
Note
All settings of the IP-Gateway will be reset to the factory settings during the update. Before
updating, please first make a note of all the details specified under basic settings and device
settings.
Perform the following steps to update your device, if necessary.
1. Get the latest software from your electrical installer.
2. Log into www.my-abb-livingspace.com with the username "admin" and the associated password.
Open menu item firmware update and upload the .tar file.
3. After the file has been sent to the IP-Gateway and installed on the device, the IP-Gateway is reachable again via
the browser.
ATTENTION: This process may take up to 10 minutes. The device must not be disconnected from the power
supply during this period.
4. Afterward, the IP-Gateway can be put into use again.
The user name and password have been reset to the factory settings admin and admin. Assign a new password if
necessary.
Re-enter the configuration data you noted before the update (basic settings, device settings).
Set the time zone.
— 32 —