Messages And Signals - Sharp UX-A1000 Operation Manual

Messages and Signals

Display messages
Note: If you have turned on the Caller ID function, see page 88 for display
messages related to Caller ID.
ADD PAPER & /
PRESS START KEY
(alternating messages)
CHANGE CARTRIDGE
CHECK CARTRIDGE
COVER OPEN
DOCUMENT JAMMED
FAX RX IN MEMORY
FUNCTION MODE
INK NEAR EMPTY
Check the printing paper. If the tray is empty, add
paper and then press the START/MEMORY key. If
there is paper in the tray, make sure it is inserted
correctly (take out the stack, align the edges evenly,
and then reinsert it in the tray) and then press the
START/MEMORY key.
This message appears after you install or replace the
print cartridge (see page 19).
The print cartridge is missing and must be installed,
or is not installed correctly.
The print compartment cover is open. Close it.
The original document is jammed. See the following
section, Clearing Paper Jams . Document jams will
occur if you load more than 20 pages at once or load
documents that are too thick (see page 54). The
document may also jam if the receiving machine
doesn't respond properly when you attempt to send a
fax.
A fax has been received in memory because the print
cartridge needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
The FUNCTION key has been pressed.
The cartridge is nearly empty (approximately one
eighth of the ink remains).
Messages and Signals
117