Table of Contents
Advertisement
Function
< Standard network connection >
The operations below using a peripheral device, that is connected to a "n" station, is possible.
- Change programs
- Monitor
- Change parameter memory (only by using JW-14PG/13PG/12PG)
< Expansion network connection >
The operations below using a peripheral device, that is connected to a "n" station, is possible.
- Change programs
- Monitor
- Change parameter memory
(only by using JW-14PG/13PG/12PG)
Operation example
This paragraph describes an operation example using the multipurpose programmer: JW-50PG.
For operations with other support tools, see the attached instruction manuals.
- Connect the JW-50PG to the JW-21MN on the ME-NET.
16
- Set communication mode
Set the communication mode of the JW-50PG to "Network CONCT." and this enables remote
programming and remote monitor.
Select "Initial setting."
Select "COM. set."
Select "Network CONCT."
Support
tool
n — 2
n — 1
n
ME-NET
Writing data (change program) during operation of the
PC is not available for hazard prevention reasons. Stop
operation of the PC prior to writing data.
Support
tool
n — 2
n — 1
n
* The JW-21MN is unusable as a junction station ("n +
ME-NET
2" station and "m" station in the figure above). Use
JW30H (JW-21MN), JW50H/70H/100H (JW-21MN).
n + 1
n + 2
*
n + 1
n + 2
m
m + 1 m + 2
Writing data (change program) during operation of the
PC is not available for hazard prevention reasons. Stop
operation of the PC prior to writing data.
(JW-50PG)
16-14
(JW-21MN)
Advertisement
Table of Contents
