Table of Contents
Advertisement
Set item
Flag area top
address
e
(communication
and PC operation
status monitor flag)
- Start/stop
operation of the
JW-21MN
r
- Write to the JW-
21MN EEPROM.
-
to
- Parameter addresses other than above mentioned are reserved areas and prohibited to be changed.
- When the JW-21MN is a slave station, set the top address and the number of sending bytes so
that the data can be within the setting range of each area (see pages 11-7 to 11-12). When any
slave stations are except JW-21MN, see the instruction manual of each device.
11
Parameter
address
(8)
007764
007765
007766
007767
007777
are equivalent to number of page 11-13.
Corresponding symbols on pages 11-7 to 11-9
*
Initial
value
(H)
E0
File address lower digits
01
File address upper digits
00
File number
80
Flag output (Yes: 80
Select "00, 01, 08, 80, 81" with hexadecimal notation.
01
(See page 16-12.)
11-6
Details (set range)
Set range: See page 11-11 to
11-12.
- Initial value: 01E0
(H)
000740
(コ 0740)
(8)
, No: 00
)
(H)
(H)
*
to
e
0
---
Advertisement
Table of Contents
