[4] Setting procedure
Set parameters of the master station following the procedure below.
①
②
③
Set top address of relay link area on slave station 01 to 77
④
⑤
Set top address of register link area on slave station 01 to 77
⑥
⑦
⑧
Set number of sending bytes of the slave station 01 to 77
⑨
Set number of sending bytes of the master station register link
⑩
Set number of sending bytes of the slave station 01 to 77
⑪
⑫
Whether the station number information should be output or not
V2
⑬
⑭
① to ⑭ are equivalent to number of page 11-5, and 11-6.
Start slave station PC operation
Turn ON the power of master station PC
Connect support tools
Stop PC operation
Stop operation of data link (007777
Set top address of the relay link area on the master station
Set data link function (004002
Set number of connecting stations
/number of offset bytes (at save memory function)
Set top address of register link area on master stations
/number of off set bytes (save memory function)
Set number of sending bytes of the master station relay link
Set connection status of slave stations
Set top address of flag area
Writing to EEPROM, start operation (007777
PC operation
11-13
[
=00
)
(8)
(H)
=01
)
(8)
(H)
(at standard function)
(8)
(at standard function)
(8)
(8)
(8)
=81
(8)
End
] : See page in chapter 11
[ 14 ]
[ 14 ]
[ 14 ]
[ 14 ]
[ 14 ]
[ 15 ]
[ 15 ]
[ 15 ]
[ 15 ]
[ 16 ]
[ 17 ]
[ 17 ]
[ 18 ]
relay link
[ 18 ]
[ 18 ]
register link
[ 19 ]
[ 19 ]
[ 20 ]
[ 21 ]
)
(H)
[ 21 ]
11