Table of Contents
Advertisement
Network Setup
Figure 3-1. Connecting an Access Control Server to a Serial Console
Access Control Server 745wl
Use a craft terminal or a computer with a terminal emulation application to access the CLI. You will need
a serial cable with DB-9 female connectors on both ends to connect to the Access Control Server. A serial
crossover cable with DB-9 female connectors is included in the accessory kit shipped with the unit. See
Appendix D, "Cable and Connector Specifications" for the pinout specifications for this connector.
Configure the terminal session on your management computer as follows:
•
Baud rate: 9600
•
Data Bits: 8
•
Parity: None
Issuing Network Setup Commands from the Serial Console
After you have connected the serial console, follow these steps to configure the Access Control Server
network parameters. These instructions assume you have not connected the unit to the network.
Step 1.
Power up the Access Control Server. You will see a series of messages on the terminal emulator
as the system boots and initializes itself.
At the end of the boot and initialization sequence you will see a prompt:
Serial Console
login:
Step 2.
At the login prompt, enter admin as the login and then enter admin as the password.
login:admin
Password: xxxxx
The system then displays the command prompt:
HP ProCurve Access Control Server 700wl Series #<MAC address>
HP 700wl Series@[0.0.0.0]:
Step 3.
To configure the system with a static IP address, enter the following commands:
3-4
Serial Cable
•
Stop bits: 1
•
Flow Control: None
ProCurve Secure Access 700wl Series Installation and Getting Started Guide
External
Management
System
Advertisement
Table of Contents
