Figure 4-2. Enabling PPTP for the 700wl Series system
Step 3.
Encryption Protocols
Under
Configuring Access Policies for Encryption
The next step is to configure the appropriate Access Policies to allow the use of encryption. You must
allow encryption for the "Unauthenticated" Access Policy so that an unknown client using encryption
can connect to the 700wl Series system, and you must enable encryption for the relevant Access Policy
that will take effect once the client has been successfully authenticated—in this case, the "Authenticated"
Access Policy.
Step 1.
From the Navigation toolbar, click the
Step 2.
Access Policies
Click the
ProCurve Secure Access 700wl Series Installation and Getting Started Guide
, put a check mark in the
RIGHTS
button to go to the Rights Manager.
tab to go to the Access Policies page, as shown in Figure 4-3.
Enable PPTP
check box, then click
Basic Configuration
Save
.
4-5