Table of Contents
Advertisement
Step 16.
If you want to allow remote access to the CLI on this unit via a remote SSH client, leave the check
Enable SSH command line interface
in the
uncheck the box.
Enable technical support access only if requested to do so by an authorized ProCurve support
engineer.
Step 17.
Save
Click
.
Note: You must enter and confirm a shared secret—the 700wl Series system does not let you
save this configuration without one.
Step 18.
To set the system date and time, and time zone if necessary, click the
Time page appears (see Figure 3-10).
Figure 3-10. Date & Time Page
Step 19.
To set the time zone, select the appropriate setting from the
Step 20.
To configure an NTP server, click the
IP address of a primary and (optionally) a secondary NTP server.
Step 21.
Save
Click
.
Step 22.
To set the date and time immediately, select the appropriate values and click
ProCurve Secure Access 700wl Series Installation and Getting Started Guide
box (this is the default). To disable remote access,
Time Zone
Set time using network time server
Network Setup
Date & Time
tab. The Date &
drop-down list.
check box, and type the
Set Time Now
.
3-13
Advertisement
Table of Contents
