Table of Contents
Advertisement
Password: xxxxx
The system then displays the command prompt:
HP ProCurve Access Control Server 700wl Series #<MAC address>
HP 700wl Series@[0.0.0.0]:
Note:
The IP address of the Access Control Server will be reflected in the prompt instead of the
0.0.0.0 address.
Step 3.
Change the administrator login and password by entering the following command:
set admin <login-name> <password> <password>
You must enter the password twice. The built-in administrator logon cannot be deleted.
Step 4.
Set the shared secret the Access Controller Modules will use to validate themselves to the
Access Control Server as follows:
set sharedsecret <secret> <secret>
You must enter the shared secret twice.
Step 5.
Verify that you can access the Administrative Console from a browser program running on a
computer connected to your network by entering the IP address of the unit:
http://<ip address>
The Administrator Logon page should appear (see Figure 3-4).
Figure 3-4. Administrator Logon
Step 6.
Log on using the username and password you set in Step 3.
Step 7.
You can now use the browser-based Administrative Console to complete the configuration of
other settings such as advanced network features, session logging, SNMP management, the
HTTP proxy feature, Wireless Data Privacy settings, and setting up authentication and access
policies for client network access.
For example, see Step 18 on page 3-13 in the section "Initial Configuration Using the
Administrative Console" for information on setting the system date, time and time zone.
See the ProCurve Secure Access 700wl Series Management and Configuration Guide for detailed
information on the features of the Administrative Console.
ProCurve Secure Access 700wl Series Installation and Getting Started Guide
Network Setup
3-7
Advertisement
Table of Contents
