Pulse input mode
2-phase multiple of 1
2-phase multiple of 2
2-phase multiple of 4
For the 1-phase pulse input and counting up pulses, check that the B phase pulse input and CH1 Down count
command (Y3) are off before performing the A phase pulse input. If at least one of the B phase pulse input
and CH1 Down count command (Y3) is on, pulses are counted down in the A phase pulse input.
1 FUNCTIONS
14
1.1 Pulse Input Modes and Counting Methods
Count timing
For counting up
φA
φB
For counting down
φA
φB
For counting up
φA
φB
For counting down
φA
φB
For counting up
φA
φB
For counting down
φA
φB
Counts on the rising edge () of A while B is off.
Counts on the falling edge () of A while B is off.
Counts on the rising edge () of A while B is off.
Counts on the falling edge () of A while B is on.
Counts on the rising edge () of A while B is on.
Counts on the falling edge () of A while B is off.
Counts on the rising edge () of A while B is off.
Counts on the falling edge () of A while B is on.
Counts on the rising edge () of B while A is on.
Counts on the falling edge () of B while A is off.
Counts on the rising edge () of A while B is on.
Counts on the falling edge () of A while B is off.
Counts on the rising edge () of B while A is off.
Counts on the falling edge () of B while A is on.