Mitsubishi Electric RD62P2E Application User's Manual page 61

CH1 Counter function selection start command
• The status of Y6 in the pulse count mode is shown.
• This signal is turned on to execute the counter function selection.
■Device number
The following table shows the device number of this output signal.
Signal name
CH Counter function selection start command
■Operation timing
The operation timing differs depending on the function used.
Function
Latch counter function
Sampling counter function
Count disable function
Cycle pulse counter function
CH1 PWM output start command (PWM output)
• The status of Y6 in the PWM output mode is shown.
• This signal is turned on to execute the PWM output.
■Device number
The following table shows the device number of this output signal.
Signal name
CH PWM output start command (PWM output)
■Operation timing
The command is valid as long as this signal is on.
CH1 Pulse measurement start command (pulse measurement)
• The status of Y6 in pulse measurement mode is shown.
• This signal is turned on to execute the pulse measurement.
■Device number
The following table shows the device number of this output signal.
Signal name
CH Pulse measurement start command (pulse
measurement)
■Operation timing
The command is valid as long as this signal is on.
CH1 Coincidence signal No.2 reset command
This signal is turned on to reset CH1 Counter value coincident (point No.2) (X6).
■Device number
The following table shows the device number of this output signal.
Signal name
CH Coincidence signal No.2 reset command
■Operation timing
The command is valid as long as this signal is on.
CH1
Y6
Timing to become valid
At the rising edge of the signal (turned off and on)
While the signal is on
CH1
Y6
CH1
Y6
CH1
Y7
CH2
YE
CH2
YE
CH2
YE
CH2
YF
APPENDICES
Appendix 2 I/O Signals
A
59