Table of Contents
Advertisement
2 - 12 SB1 Integrator Guide
Developer Back Housing
The Developer Back Housing provide USB connection for communication with a host computer.
Setup
To use the Developer Back Housing, the back housing of the SB1 must be removed and replaced with the
Developer Back Housing. The Developer Back Housing Kit contains:
Developer Back Housing
•
Four long screws
•
Two short screws
•
Screwdriver
•
USB cable.
•
To install the Developer Back Housing:
Power off the SB1.
1.
Turn the SB1 face down on a table.
2.
Using the supplied screwdriver, remove six screws securing the back housing to the SB1.
3.
Remove Back Housing Screws
Figure 2-12
Remove the back housing.
4.
Align the Developer Back Housing with the SB1.
5.
Lower the Developer back Housing onto the SB1.
6.
Advertisement
Table of Contents
