Table of Contents
Advertisement
The RebootEnableOverride package. The abup30 package from in step 1.
a.
Create a Policy or action to deploy the bundle from step 2.
3.
When a job to execute the bundle from step 2 is executed, the MSP Agent is updated and a cold boot is
•
performed to activate the new updated MSP Agent.
It is generally recommended to have a policy to deploy the latest version of the MSP Agent to all
•
devices managed by MSP and to update the bundle referenced by that policy whenever a new version
of the MSP Agent becomes available.
MSP Agent Update Using an MSP Server and the RD Client
The MSP Client software is pre-installed on the SB1 and can be updated by installing an MSP Client Software
Update package. When an SB1 is managed by MSP on an ongoing basis, it is highly recommended to update
to the latest available version of the MSP Client software. If only staging is used, it may not be necessary or
even advisable to update to the MSP Client software from the version that is pre-installed.
Initial staging when the SB1 is out of the box must be performed using the version of the RD Client
pre-installed on the SB1. While newer versions of the MSP Client software might be available, and while a
newer version might include additional RD Client features, such features could not be utilized unless staging
was performed multiple times. A first staging operation would need to be performed to update the RD Client
then a second staging operation would need to be performed. The first staging operation would need to stay
within the capabilities of the original RD Client and only the second staging operation could utilize any new
capabilities of the new RD Client.
In addition, if new capabilities are required to get onto a desired network, it may be impractical to perform the
first staging operation over that network. While there may be cases in which multiple staging operations might
be acceptable, in most cases a single staging operation is preferred, thus requiring that staging to be
performed using the capabilities of the RD Client that is part of MSP Client software that is pre-installed on the
SB1.
To update the MSP Agent using an MSP Server:
The SB1 is supported by the standard MSP Agent Update packages.
1.
• Most commonly, abup30 package with a version of ddd_xxx should be used.
• Alternately, the abup30 package with a version of ddp_xxx could be used, if support for Detached
Jobs is required. Refer to the MSP Client Software Guide for more information.
Since the SB1 does not support warm boot, the standard MSP Agent Update packages fail if used by
2.
itself. The RebootEnableOverride package is used to override default behavior and allow the standard
MSP Agent Update packages.
Create a bundle containing the desired deployment steps:
3.
RebootEnableOverride package from step 2.
a.
abup30 package from step 1.
b.
Create a Staging Profile with some or all of the following:
4.
WLAN settings. See
a.
Relay Server settings. See
b.
Bundle created in step 3.
c.
Preparing Generic Staging Content on page
Preparing Generic Staging Content on page
Staging and Deployment 4 - 29
4-15.
4-15.
Advertisement
Table of Contents
