Drilling Cycle, Counter Boring Cycle (G82) - Siemens SINUMERIK 802D sl Programming Manual

04.07
4.1.5

Drilling cycle, counter boring cycle (G82)

Normal drilling can be carried out by means of this cycle. Upon reaching the drilling
depth Z, a programmed dwell time is carried out after which the retraction move-
ment is performed in rapid traverse.
Format
G82 X... Y... R... P... F... K... ;
X,Y: Hole position
Z: Distance from point R to the bottom of the hole
R: The distance from the initial level to R level
P: Dwell time at the bottom of a hole
F: Cutting feed rate
K: Number of repeats
Fig. 4-10
Axis switching
The canned cycle must be canceled before the drilling axis can be changed.
Drilling
Drilling is not carried out in a block that does not contain X, Y, Z, R, or any other
axes.
Cancel
G codes of group 01 (G00 to G03) and G82 must not be specified in a single block.
Otherwise, G82 is canceled.
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
G82 (G98)
Initial level
Point R
Point Z
Drilling cycle, counter boring cycle (G82)
Enhanced Level Commands
4.1 Program support functions (1)
G82 (G99)
Point R
Point R level
Point Z
4-105