Siemens SINUMERIK 802D sl Programming Manual page 217

04.07
10704
MD number
Default setting:
Changes effective after:
Data type: BYTE
Meaning:
This MD cannot SINUMERIK 802D sl.
10706
MD number
Default setting:
Changes effective after:
Data type: BYTE
Meaning:
This MD cannot SINUMERIK 802D sl.
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) - - 04.07 Edition
DRYRUN_MASK
Activating dry run feed
Minimum input limit: - -
Protection level:
DRYRUN_MASK == 0
Dryrun must only be activated or deactivated at the end of a block.
DRYRUN_MASK == 1
Dry run feed may be activated or deactivated even during program execution
Note: Once dry run feed has been activated, the axes are stopped for the duration of
the reorganization.
DRYRUN_MASK == 2
Dryrun can be activated or deactivated in any phase and the axes are not stopped.
Note: However, the function is only effective upon using a block which comes "later"
in the program run. The function takes effect on the next (implicit) Stop Reset.
SLASH_MASK
Activating the block skip function
Minimum input limit: - -
Protection level:
SLASH_MASK == 0
The block skip function can only be switched over at the end of a block.
SLASH_MASK == 1
When SLASH_MASK == 1 the block skip function may be activated even during program
execution.
Note: Once block skip has been activated, the axes are stopped for the duration of
the reorganization.
SLASH_MASK == 2
Block switchover is possible in any phase.
Note: However, the function is only effective upon using a block which comes "later"
in the program run. The function takes effect on the next (implicit) Stop Reset.
Machine and Setting Data
D.1 Machine/Setting data
Maximum input limit: - -
Unit: - -
Applies with effect from SW version:
Maximum input limit: - -
Unit: - -
Applies with effect from SW version:
D-217