Siemens SINUMERIK 802D sl Programming Manual page 119

04.07
Thread lead
The thread lead is obtained from the expression 'feedrate spindle speed' in the
feed--per--minute mode. The thread lead equals the feedrate speed within the
speed--per--revolution mode.
Tool length compensation
The offset is applied at the time of positioning to point R if a tool length compensa-
tion (G43, G44, or G49) is determined in the canned cycle.
Axis switching
The canned cycle must be canceled before the drilling axis can be changed. An
alarm is issued if the drilling axis is changed in rigid mode.
S command
An alarm is issued if a speed higher than the maximum speed for the gear being
used is specified.
F command
An alarm is issued if a value exceeding the upper limit of cutting feedrate is speci-
fied.
Unit of F command
G94
G95
Cancel
G codes of group 01 (G00 to G03) and G84 must not be specified in a single block.
Otherwise, G84 is canceled.
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
Metric input
1 mm/min 0.01 inch/min
0.01 mm/rev 0.0001 inch/rev
Enhanced Level Commands
4.1 Program support functions (1)
Inch input Remarks
Decimal point pro-
gramming allowed
Decimal point pro-
gramming allowed
4-119