Easy Replacement Function For One Slave Module - Mitsubishi Electric MELSEC iQ-R AnyWireASLINK User Manual

1.13

Easy Replacement function for One Slave Module

When the slave module is replaced with the one of the same type, this function automatically sets the address and the device
parameter with no need of using an address writer.
When using this function, check the production information of the RJ51AW12AL. ( Page 133 Added or
Changed Functions)
After the slave module replacement, the RJ51AW12AL checks that the new slave module has the same type as the old one.
When the types of the old and new slave modules match, the following backup data is restored to the new slave module so
that the new slave module can be used.
• Module ID
• Device parameters 1 to 19 (parameter value detected by the automatic address detection)
*1 Parameter information acquired through parameter access cannot be restored.
Applicable slave module
For slave modules that support this function, consult Anywire Corporation.
Replace the slave module with the one that meets the following conditions.
• Unused slave module of which address and device parameter are not changed
• Slave module to which the teaching is not executed
*1
1.13 Easy Replacement function for One Slave Module
1
1 FUNCTIONS
41