Figure 3-10. Memory Locations - PowerEdge M605
General Memory Module Installation Guidelines - PowerEdge M605
To ensure optimal performance of your system, observe the following
guidelines when installing your system memory.
•
Memory modules must be installed in pairs of identically-sized DIMMs,
beginning with slots A1 and A2 (processor 1) and B1 and B2 (processor 2, if
installed). These slots are marked by white ejector tabs.
•
All memory modules in the blade must be identical in speed and
technology. The memory modules in each pair must be the same size.
•
In two-processor configurations, memory must be installed in the same
configuration (symmetrically) for both processors.
•
If pairs of memory modules of different sizes are installed, the larger
capacity memory modules must be installed in the lower numbered slots.
•
Memory sparing is supported if four (single-processor systems) or eight
(dual-processor systems) memory modules are installed.
B4
B3
B2
B1
Installing Blade Components
A1
A2
A3
A4
115