Dell PowerEdge M605 Hardware Owner's Manual page 149

Figure 3-28. Removing and Installing the Hard-Drive Backplane (PowerEdge M605
Shown)
1
1 hard-drive backplane
3 retention hooks (3)
5 backplane connector on system
board
5 To install the hard-drive backplane:
Hold the backplane with the drive connectors facing towards the hard
a
drive bays.
Position the backplane so that the retention hooks on the end of the
b
drive bay are aligned with the corresponding slots in the backplane.
Press the backplane into place until the connector. is fully seated and
c
the latches at each end snap over the upper edge of the board.
6 Replace the hard drive(s).
If you are installing two drives, be sure and reinstall them in their original
locations.
2
5
3
4
2 hard-drive connectors (2)
4 latches (2)
Installing Blade Components
149