Dell PowerEdge M605 Hardware Owner's Manual page 139

Figure 3-22. Installing and Removing an HT Bridge Card (PowerEdge M805 Only)
4
1 HT bridge card
3 processor shield
Installing an HT Bridge Card
1 Perform the following steps to prepare the two sockets on the new system
board:
Remove the processor filler blank
a
Lift the plastic processor socket cover from the socket.
b
Unlatch and rotate the socket-release lever 90 degrees upward.
c
Lift the processor shield.
d
Repeat steps a through d to prepare the second processor socket.
e
2
1
2
4
Installing Blade Components
socket-release lever
notch in card
3
139