Enclosure Control Panel Assembly (Service Only); Removing The Enclosure Control Panel - Dell PowerEdge M605 Hardware Owner's Manual

6 Install the iKVM module. See "Installing an iKVM Module" on page 166.
7 Install the CMC module. See "Installing a CMC Module" on page 165.
8 Install the fan modules. See "Installing a Fan Module" on page 162.
9 Install the power supply modules. See "Installing a Power Supply Module"
on page 160.
10 Install the blades. See "Installing a Blade" on page 98.

Enclosure Control Panel Assembly (Service Only)

Removing the Enclosure Control Panel

CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Press the system power switch to turn off the system. See "System Control
Panel Features" on page 14.
2 Remove the blades. See "Removing a Blade" on page 96.
3 Remove the bezel. See "Removing the Enclosure Bezel" on page 168.
4 Remove the two screws securing the control panel to the enclosure. See
Figure 4-10.
Installing Enclosure Components
173