Rear Cover (O/D Brake Piston Assembly); Planetary Sun Gear No.1 Assembly - Suzuki Ignis Service Manual

REAR COVER (O/D BRAKE PISTON ASSEMBLY)

DISASSEMBLY
1) Remove O/D brake piston (1) from rear cover (2).
NOTE:
If O/D brake piston is hard to take it out, force low-pres-
sure compressed air (1 kg/cm
hole (5) shown in figure and pop out piston into a rag.
2) Remove O-ring (3) and seal ring (4).
Replace them, if damaged.
ASSEMBLY
1) Install seal rings to rear cover and O-rings to O/D brake pis-
ton.
2) Apply grease to O-rings and install O/D brake piston to rear
cover.

PLANETARY SUN GEAR NO.1 ASSEMBLY

DISASSEMBLY
1) Remove one-way clutch retainer (1) from planetary sun gear
No.1 assembly.
NOTE:
Do not reuse retainer.
2) Remove one-way clutch bearings (2), one-way clutch (3),
inner race (4) and washer (5) from planetary sun gear No.1
(6).
ASSEMBLY
Reverse removal procedure noting followings.
• When installing retainer, fit 2 hooks of retainer on planetary
sun gear No.1 and tap the other 2 hooks with plastic ham-
mer.
After assembling, make sure that :
• There is no clearance between retainer and bearing.
AUTOMATIC TRANSMISSION (4 A/T) 7B-115
2
, 15 psi, 100 kPa max) into