5.
MOUNTING THE AP300 AGAINST A WALL
Procedure for mounting the AP300 to the wall:
1.
Remove the mounting plate from the AP300 cabinet.
Push clip up to
take mounting
plate off.
2.
Mount the mounting plate to the wall.
3.
Make sure that the CAT 5 cable to the cabinet has the correct length.
4.
If necessary, mount the RJ45 connector to the cable using the tool for mounting an
RJ45 connector plug to a Category 5 cable. For standard colour schemes, consult
Chapter 7. WIRE COLOUR CODING FOR CATEGORY 5 CABLES.
12
All rights reserved. Reproduction in whole or in part is prohibited without the written consent of the copyright owner
Figure 13. How to take the mounting plate off.
Figure 14. Mounting plate..
AP300 Customer Engineer Manual
March 2010