Installing A Dap/Rfp With External Antennas - NEC AP300 Installation Manual

3.

INSTALLING A DAP/RFP WITH EXTERNAL ANTENNAS

Before you start installing the cabinet, make sure that you have the installation materials as
described in Section 1.1 TOOLING
Also make sure that you have the AP300E version together with the Directional antenna
and two equal cables for connecting the directional antenna to the AP300E.
Procedure for installing the Outdoor Box with AP300E with directional antenna:
1. Open the Cabinet. To open the cabinet, use a screw driver that fits into the four
plastic screws at the front side of the cabinet. Unfasten the screws.
2. Remove the cover from the cabinet. The contents of the cabinet is shown in Figure
12. Contents of the box.
3. Remove the foam contents from the cabinet.
4. At the right hand side of the cabinet, you will have to drill a hole for the cable inlet.
Mark the hole as follows:
10
All rights reserved. Reproduction in whole or in part is prohibited without the written consent of the copyright owner
Figure 12. Contents of the box.
Outdoor Cabinet Isolated - Installation Manual March 2010