NEC AP300 Installation Manual page 46

21. Lead the coax antenna cables via the top side of the foam and determine the position
of the directional antenna. Note that the hole in the foam is not big enough for the
antenna. This is done on purpose, in order to allow various positions of the direction
antenna.
22. Cut the hole for the directional antenna to the correct size, to be able to push the
antenna in the hole.
Figure 24. Cutting the foam to allow the antenna to fit into it, in the required position.
March 2010
All rights reserved. Reproduction in whole or in part is prohibited without the written consent of the copyright owner
Figure 23. Antenna does not fit into the hole.
Outdoor Cabinet Installation Manual 17