Sony DCR-IP210 Operating Instructions Manual page 160

Connecting your camcorder to your computer using the USB cable
(For Windows users)
Viewing images recorded on a "Memory Stick"
(1) Insert a "Memory Stick" into your camcorder.
(2) Connect the AC power adaptor and set the POWER switch to MEMORY.
(3) Connect the
(4) Follow the on-screen messages so that the Add Hardware Wizard recognizes
You cannot install the USB driver if a "Memory Stick" is not in your camcorder
Be sure to insert a "Memory Stick" into your camcorder before installing the USB
driver.
160
(USB) jack on your camcorder to the USB connector on your
computer using the supplied USB cable.
USB MODE appears on the LCD screen of your camcorder. Your computer
recognizes your camcorder, and the Add Hardware Wizard starts.
that the USB drivers have been installed. The Add Hardware Wizard starts
two times because two different USB drivers are installed. Be sure to allow the
installation to complete without interrupting it.
(USB) jack
USB connector
USB cable (supplied)