Playback - Basics; Playing Back A Tape - Sony DCR-IP210 Operating Instructions Manual

— Playback – Basics —

Playing back a tape

You can monitor the recorded tape on the LCD screen. If you close the LCD panel, you
can monitor the playback picture in the viewfinder. You can also control playback using
the Remote Commander.
(1) Prepare the power source and insert the recorded tape.
(2) Set the POWER switch to VCR.
(3) Open the LCD panel.
(4) Press
(5) Press
(6) Adjust the volume following the steps below.
(7) Press
To return to FN
Press EXIT after step 7.
To stop playback
Press
If you leave the power on for a long time
Your camcorder gets warm. This is not a malfunction.
42
The VCR lamp lights up.
to rewind the tape.
to start playback.
1 Press FN to display PAGE1 (p. 27).
2 Press VOL. The screen for the volume adjustment appears.
3 Press –/+ to adjust the volume.
– : To decrease the volume
+ : To increase the volume
OK. The display returns to PAGE1.
2
POWER
on the LCD screen or STOP on the Remote Commander.
4
6,7
FN
VOL
5
OK
– VOL +
Bar indicator